Vrrp-Group - Dell S6100 Configuration Manual

Version
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.8.0
Usage Information
This command applies to all the VRRP interfaces on a system. When you use this command with the vrrp
delay minimum command, the later timer rules VRRP enabling. For example, if vrrp delay reload is 600
and vrrp delay minimum is 300:
•
•
For the delay timers to take effect, save the configuration and reload the system.
Related Command
•

vrrp-group

Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
Syntax vrrp-group vrrp-id
Parameters
vrrp-id
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.0.2.0
Description
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up
and configured for VRRP.
When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300
seconds (5 minutes) to bring up VRRP on that interface.
vrrp delay minimum — sets the delay time for VRRP initialization after a line card reboot.
Enter a number as the group ID. The range is from 1 to 255.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Virtual Router Redundancy Protocol (VRRP) 1723