Establishing An Active Link With The Mobile Station; Making A Base Station Originated Call - Agilent Technologies 8960 10 Series Reference Manual

Establishing an Active Link with the Mobile Station

Making a Base Station Originated Call

The process for making a base station originated call is to:
1. If necessary, configure the traffic channel parameters for the call assignment. See
page 286.
2. If necessary, set the IMSI state. See
Example 1.
OUTPUT 714;"CALL:PAGING:IMSI ""01012345678901"""
would set the paging IMSI to 01012345678901.
3. If necessary, set the repeat paging state. See
Example 2.
OUTPUT 714;"CALL:PAGING:REPEAT ON"
would turn on repeat paging.
4. Configure the necessary call processing connect/disconnect synchronization conditions.
See "Call Processing State Synchronization" on page
5. Page the mobile station by sending the call originate command to the test set.
Example 3.
OUTPUT 714;"CALL:ORIGINATE"
would start the process of making a base station originated call.
IMPORTANT To verify that the origination is successfully completed, see
Synchronization" on page 35
"CALL:PAGing:IMSI" on page
"CALL:PAGing:REPeat[:STATe]" on page
35.
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\prog_call_setup.fm
Establishing an Active Link with the Mobile Station
"CALL:TCHannel" on
268.
269.
"Call Processing State
28