Agilent Technologies 8960 10 Series Reference Manual page 416

SETup:ORFSpectrum
SETup:ORFSpectrum:MODulation:FREQuency[:OFFSet]
Function Specifies/queries the list of output RF spectrum due to modulation frequency offsets. Each offset
listed in the command is turned on by default. If no frequency offsets (null list) are sent, the
output RF spectrum due to modulation measurement will not be made. The units
(GHZ|MHZ|KHZ|HZ) are optional, if no units are specified than units default to HZ. see
"Output RF Spectrum Measurement Description" on page 75
Range: 0 to 22 comma-separated values ranging from −1.8 MHz to −10 Hz, and +10 Hz to +1.8
Setting
MHz
Resolution: 10 Hz
Range: 0 to 22 comma-separated values ranging from −1.8 MHz to −10 Hz, and +10 Hz to +1.8
Query
MHz
Resolution: 10 Hz
*RST Setting Offset 1: 400.0 kHz
Offset 2: 600.0 kHz
Offsets 3 to 22: off
Programming Example
OUTPUT 714;"SETUP:ORFSPECTRUM:MODULATION:FREQUENCY:OFFSET 400 KHZ, 700 KHZ"
!Turns on the first two ORFS due to modulation measurement offsets and sets
!them to 400 kHz and 700 kHz offsets. All other offsets are in the off state.
OUTPUT 714;"SETUP:ORFSPECTRUM:MODULATION:FREQUENCY:OFFSET 700 KHZ" !Turns on
OUTPUT 714;"SETUP:ORFSPECTRUM:MODULATION:FREQUENCY:OFFSET" !Turns all offsets
416
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_setup_orfspectrum.fm
!the first
!ORFS due to
!modulation
!measurement
!offset and
!sets it to
!A 700 kHz
!offset. All
!other
!offsets are
!in the off
!state.
!for ORFS due to
!modulation
!measurement to the
!off state.