Agilent Technologies 8960 10 Series Reference Manual page 550

Rear Panel Connectors
10 MHZ REF IN
This BNC connector accepts an external 10 MHz timebase signal. The nominal input impedance is 50 ohm.
This version of test set can only accept a 10 MHz timebase signal.
10 MHZ REF OUT
This BNC connector provides a 10 MHz timebase signal to external test equipment. The accuracy of this signal
is determined by the timebase used. The nominal output impedance is 50 ohm with a typical level of 0.5 V rms.
Related Topics
*******************************************************
"Setting Frame Trigger Parameters" on page 515
"Timebase Description/Configuration" on page 568
"SYSTem:ROSCillator" on page 495
"Configuring the Test Set's GPIB Address" on page 557
"Configuring the Test Set's LAN" on page 560
*****************************************************
550
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\gen_rearpanel_con.fm