ABORt[:ALL]
Function
Stops any and all measurements that are active. See
If the trigger arm is set to single, see
151
the measurements will go to the idle state.
If the trigger arm is set to continuous the measurements will re-arm and initiate again.
Setting
Range
• AAUDio
• BERRor
• DAUDio
• DPOWer
• FBERror
• IQTuning
• ORFSpectrum
• PFERror
• PVTime
• TXPower
Programming Example
OUTPUT 714;"ABORT:ALL" !Aborts all active measurements in progress.
"Measurement States" on page 150
"Trigger Arm (Single or Continuous) Description" on page
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_abort.fm
ABORt
217