Developing Code - Agilent Technologies 8960 10 Series Reference Manual

Diagram Conventions

Developing Code

It is recommended that you set the Test Set's operating environment to debug. To set the Test Set debug mode
to "ON" use the following syntax:
SYSTem:COMMunicate:GPIB:DEBug ON
Units-of-Measure
If you do not specify units-of-measure in your code the following table indicates the default units-of-measure
that will be assumed.
Amplitude (linear)
Frequency
Power (logarithmic)
Time
214
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_Syntax_Book_Diagr_Convent.fm
V
HZ
dBm
S