Making a Mobile Station Originated Call
The process for making a mobile station originated call is to:
1. If necessary, configure the necessary traffic channel parameters for the call assignment. See
"CALL:TCHannel" on page
2. Configure the necessary call processing connect/disconnect synchronization conditions.
See
"Call Processing State Synchronization" on page
3. Initiate a call from the mobile station.
There is no facility in the test set to initiate a call from the mobile station. This must be
NOTE
accomplished manually or through a test bus built-in to the mobile station.
To verify that the origination is successfully completed, see
IMPORTANT
Synchronization" on page 35
Operating Considerations
The test set must be in active cell operating mode. The correct frequency band must be selected.
286.
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\prog_call_setup.fm
Establishing an Active Link with the Mobile Station
35.
"Call Processing State
29