Supplemental Performance Characteristics; Frequency Range; Additional Errors (With Open/Short Correction) - Agilent Technologies 16034G Operation Manual

Supplemental Performance Characteristics

This section provides useful data on the 16034G. These supplemental performance
characteristics should not be considered specifications.

Frequency Range

With OPEN/SHORT correction
With OPEN/SHORT/LOAD correction

Additional Errors (With OPEN/SHORT correction)

Additional errors are calculated as follows.
|Z| Measurement
Additional error Ze [%] of the |Z| measurement is calculated by substituting the
values in the table below into the following equation.
Ze [%] = ± {A + (Zs/Zx + Yo ×Zx) × 100}
where
A [%]
Zs [Ω]
Yo [S]
Zx [Ω]
Zs
Yo
A
where f is frequency (MHz).
D Measurement
Additional error De of the D measurement is calculated by additional error Ze [%]
of |Z| measurement as follows.
If Dx ≤ 0.1:
If 0.1 < Dx ≤ 0.5:
where Dx is the measured value of D. It is necessary for Ze to be below 10 %.
Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Specifications and Supplemental Performance Characteristics
Supplemental Performance Characteristics
≤
3 MHz
Additional Error (Proportional Error)
Short Repeatability (Impedance)
Open Repeatability (Admittance)
Measured Value (Impedance)
-3
{10 + 13 × ( f / 10 )} × 10
-9
{5 + 500 × ( f / 10 )} × 10
2
0.5 × ( f / 10 ) [%]
De = Ze / 100
De = ( Ze / 100) × (1 + Dx)
≤
110 MHz
[Ω]
[S]
21