Agilent Technologies 8960 10 Series Reference Manual page 513

Configuring the Broadcast Channel (BCH)
Paging IMSI
OUTPUT 714;"CALL:PAG:IMSI '001012345678901'"
would set the paging IMSI to 001012345678901. See "CALL:PAGing:IMSI" on page 268.
Repeat Paging
OUTPUT 714;"CALL:PAG:REP OFF"
would turn repeat paging off. See "CALL:PAGing:REPeat[:STATe]" on page 269.
Paging Mode
OUTPUT 714;"CALL:PAG:MODE REORG"
would set the paging mode so that the MS will sent a page on the next available paging subchannel without
waiting for the mobile station's pre-selected paging subchannel. See "CALL:PAGing:MODE" on page 269.
Paging Multiframes
OUTPUT 714;"CALL:PAG:MFR 5"
would set the number of multiframes between paging subchannels. See "CALL:PAGing:MFRames" on page
270.
Get IMEI at Call Setup
OUTPUT 714;"CALL:IMEI:AUTO ON"
would cause the test set to automatically request the mobile station's IMEI at call setup. See "CALL:IMEI" on
page 250.
TX Level FACCH Signaling
OUTPUT 714;"CALL:SIGN:MS:TXL:FACCH ON"
would set the base station emulator to use both See "CALL:SIGNaling" on page 282.
BA Table (broadcast allocation table)
OUTPUT 714;"CALL:BA:TABLE:DCS 512,612,787"
would set the first three DCS base allocation table entries to 512, 612, 787. The remaining 13 would be turned
off. See "CALL[:CELL]:BA:TABLe:DCS" on page 230.
3 Digit MNC for PCS
OUTPUT 714;"CALL:PMNCODE:STATE ON"
configures the PCS BCCH to use the PCS, 3-digit MNC when the current cell band is PCS. See
"CALL[:CELL]:PMNCode:STATe" on page 272.
NOTE Can only be set when Cell Activated State = OFF.
513
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\gen_bse_bch.fm