Agilent Technologies 8960 10 Series Reference Manual page 510

Active Cell Operating Mode
Setting the Active Cell Mode State
The
control of all signalling operations, uplink demodulation and downlink (BCH & TCH) generation on or off. See
"CALL[:CELL]:ACTivated[:STATe]" on page 227.
When cell activated state is on and the test set is in Operating Mode active cell, burst type is determined by
protocol. When the cell activated state is off, (Operating Mode active cell or test) the burst type is determined
by the "CALL:BURSt:TYPE" on page 239 command.
Example 6. Command Syntax:
CALL[:CELL[1]]:ACTivated[:STATe]<ON|1|OFF|0>
Example 7. Programming Example:
OUTPUT 714;"CALL:ACT ON"
Related Topics
***********************************************************************************
"Configuring the Broadcast Channel (BCH)" on page 511
"CALL:OPERating" on page 266
"Configuring the Traffic Channel (TCH)" on page 521
***********************************************************************************
510
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\gen_bse_active.fm