Agilent Technologies 8960 10 Series Reference Manual page 548

Rear Panel Connectors
BASEBAND I/0
Not functional for this release.
CLK IN
Not functional for this release.
COUNTER IN
Not functional for this release.
DATA IN
Not functional for this release.
DATA VALID IN
Not functional for this release.
ETHERNET TO FRONT PANEL
This RJ-45 connector is used with a separate LAN jumper cable to connect the front panel DATA connector to
the rear panel LAN PORT.
The ETHERNET TO FRONT PANEL connector on the rear panel is connected to the DATA connector on the
front panel internally, as a convenience to the user the LAN connection to the test set may be routed to the
front panel DATA connector for access. The user must connect the rear panel LAN PORT to the rear panel
ETHERNET TO FRONT PANEL connector with the LAN jumper cable in order to use the front panel DATA
connector.
The LAN jumper cable, part number E5515-61160, is supplied with the test set.
EXT INTERFACE CONTROL
Not functional for this release.
EXT SIG GEN/FRAME SYNCH
Not functional for this release.
FM MOD IN
This BNC connector let's you use an external signal to frequency modulate the test set's RF generator. It has a
fixed sensitivity of 20 KHz/volt, and a frequency range of 100Hz to 20 KHz.
GPIB
The GPIB connector allows communications with compatible devices.
548
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\gen_rearpanel_con.fm