Agilent Technologies 8960 10 Series Reference Manual page 521

Configuring the Traffic Channel (TCH)
Configuring the Traffic Channel (TCH)
The traffic channel parameters are configured using the following call processing subsystem commands.
For complete command syntax, see "CALL:TCHannel" on page 286.
TCH Parameters
• Traffic Channel Band
• Traffic Channel (ARFCN)
• Timeslot
• Mobile Loopback
• Speech
• Max Frames Allowed for Assignment
• Channel Mode
Examples:
Traffic Chan Band
OUTPUT 714;"CALL:TCH:BAND DCS"
would set the cell's traffic channel band to the DCS band. See "CALL:TCHannel:BAND" on page 289.
Traffic Channel
OUTPUT 714;"CALL:TCH 45"
would set the active cell's traffic channel number to 45. See "CALL:TCHannel[:ARFCn][:SELected]" on page
287.
OUTPUT 714;"CALL:TCH:DCS 65"
would set DCS cell's traffic channel number to 65. See "CALL:TCHannel[:ARFCn]:DCS" on page 287.
Timeslot
OUTPUT 714;"CALL:TCH:TSL 4"
would set the traffic channel timeslot to 4. See "CALL:TCHannel:TSLot" on page 291.
Mobile Loopback
OUTPUT 714;"CALL:TCH:LOOP OFF"
would turn off loopback of the traffic channel data. See "CALL:TCHannel:LOOPback" on page 291.
Speech
OUTPUT 714;"CALL:TCH:DOWN:SPE SIN1000"
would set the traffic channel downlink speech source to 1 kHz. See "CALL:TCHannel:DOWNlink:SPEech" on
page 290.
521
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\gen_bse_tch.fm