Call:connected - Agilent Technologies 8960 10 Series Reference Manual

CALL:CONNected

CALL :CONNected
"Diagram Conventions" on page 213
CALL:CONNected[:STATe]?
Function Queries the connected/disconnected state of the call. 1 is returned if the call is in the connected
state. 0 is returned if the call is in the idle (that is, disconnected) state. If the call is in any state
other than connected or idle, the query will hang until the call state transitions to the
connected or idle state. When used in conjunction with the CALL:CONNected:ARM and
CALL:CONNected:TIMeout commands, the CALL:CONNected:STATe? command allows the
control program to synchronize to call connection/disconnection. See
Synchronization" on page
Query Range: 0|1
*RST Setting 0
Programming Example
OUTPUT 714;"CALL:CONNECTED:STATE?" !Returns 1 if call connected,
? (returns 1|0)
[:STATe]
:ARM
[:IMMediate]
:STATe?
:TIMeout <sp><num value>[<S|MS|US|NS>]
?
35.
!0 if call disconnected.
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_call_connected.fm
:DONE?
:OPComplete?
:SEQuential
:WAIT
(returns 1|0)
"Call Processing State
CALL:CONNected
240