Agilent Technologies 8960 10 Series Reference Manual page 395

SETup:FBERror:MANual:DELay
Function Sets/queries the number of frames the test set will use to correlate uplink information bits with
downlink information bits when loopback delay control mode is manual (auto off). To set the
loopback delay mode to manual, refer to
This value is displayed in the TDMA Frames Delay field when Auto is not displayed. (If you want
to display this value and Auto is currently displayed, press the front panel key labeled
MANUAL).
Refer to
and how it is used in this measurement.
Setting Range: 0 to 26
Resolution: 1
Query Range: 0 to 26
Resolution: 1
*RST 5 (loopback delay control is reset to automatic (auto on).
Related Topics see "SETup:FBERror:LDControl:AUTO" on page 394
Programming Example
OUTPUT 714;"SETUP:FBERROR:MANUAL:DELAY 6" !Set frame delay to 6 frames.
SETup:FBERror:SLControl
Function Selects/queries the Signalling loopback control state for an FBER measurement.
When the state is set to on, the test set will automatically send the command for Type C
burst-by-burst) loopback to the MS when a FBER measurement is activated, and then
(
set loopback to off when the measurement is complete.
The loopback type is controlled manually from the Mobile Loopback F12 key, see
"CALL:TCHannel:LOOPback" on page 291
command.
Setting Range: 1 | ON | 0 | OFF
Query Range: 1 | 0
*RST 1 | ON
Programming Example
OUTPUT 714;"SETUP:FBERROR:SLCONTROL ON" ! Sets the Signal Loop Control state to on.
"Fast Bit Error Measurement Description" on page 69
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_setup_fberror.fm
"SETup:FBERror:LDControl:AUTO" on page
for a description of frame delay
for a program example and details about the
SETup:FBERror
394.
395