Configuring The Traffic Channel Parameters - Agilent Technologies 8960 10 Series Reference Manual

Step 2: Configure the Base Station Emulator (BSE)

Configuring the Traffic Channel Parameters

The traffic channel parameters are configured using the CALL processing subsystem commands shown in the
following table.
Traffic Channel Settable Parameters
Parameter
TCH Band ("1" )
Channel Number
("2" )
Loopback Mode
Timeslot
Downlink Speech
Source
XXXXXXXXX
Table Footnotes
1 The TCH band setting becomes the selected band (see Note 2).
2 Sets the TCH channel for the TCH band selected with the TCH Band command (see Note 1).
Example 2. Programming Example:
The following program example illustrates proper use of the BSE TCH configuration commands. Not all
parameters are accessed.
OUTPUT Test_set;"CALL:TCH 45"
OUTPUT Test_set;"CALL:TCH:TSL 4"
162
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\prog_prog_guide_step2.fm
Command Syntax
CALL:TCHannel:BAND <PGSM|EGSM|DCS|PCS>
CALL:TCHannel[:ARFCn][:SELected] <numeric value>
OR
CALL:TCHannel[:ARFCn]:<PGSM|EGSM|DCS|PCS> <numeric value>
CALL:TCHannel:LOOPback <OFF|A|B|C>
CALL:TCHannel:TSLot <numeric value>
CALL:TCHannel:DOWNlink:SPEech <NONE|ECHO|PRBS15|SIN300|SIN1000|SIN3000>
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX