Measurement Event Synchronization
STATUS:OPERATION:NMRREADY:GSM
The STATus:OPERation:NMRReady:GSM command allows the program to immediately branch to the next
operation or command without continuing through a loop as in INITiate:DONE? See
"STATus:OPERation:NMRReady:GSM Condition Register Bit Assignment" on page 451
for more details about
this command.
The user must enable the following so that as soon as the enabled NMRReady bit is true the program moves
on.
• Positive or negative transition filter.
See"Transition Filters" on page
145.
• STATus:OPERation:NMRReady:GSM bit for the measurement desired.
• STATus:OPERation:NMRReady bit (4 for GSM) for the required system. See
"STATus Subsystem
Description" on page 437
or
"Status Subsystem Overview" on page
137.
• STATus:OPERation bit (512 for NMRReady).
• Service Request Enabling (*SRE 128 for NMRReady). See .
The
"STATus:OPERation:NMRReady:GSM Condition Register Bit Assignment" on page 451
status register
provides status reporting on the following measurement completions:
• TX Power
• Power vs. Time
• Phase/Frequency Error
• Output RF Spectrum
• Analog Audio
• Decoded Audio
• Fast Bit Error
• Bit Error
• I/Q Tuning
• Dynamic Power
134
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\prog_meas_synch.fm