Agilent Technologies 8960 10 Series Reference Manual page 382

SETup:AAUDio
SETup:AAUDio:EXPected:VOLTage[:PEAK]
Function Sets/queries the maximum expected peak voltage (clipping level) of the Analog Audio signal to be
measured. The units (V|MV|UV) are optional, if no units are specified then units default to V.
see "SETup:AAUDio" on page 380
Setting Range: 10 mV to 20 V peak / Resolution: 0.1 mV
Query Range: 10 mV to 20 V peak / Resolution: 0.1 mV
*RST setting 20V
Programming Example
OUTPUT 714;"SETUP:AAUDIO: EXPECTED:VOLTAGE 5 V" !Sets the clipping level of
SETup:AAUDio:FILTer[:SFRequency]
Function Sets/queries the state to on and the center frequency for the 100 Hz bandpass filter applied to
Analog Audio measurements. Units (KHZ|HZ) are optional, if no units are specified then units
default to Hz.
Setting Range: 200 Hz to 8.0 kHz / Resolution: 1 Hz
Query Range: 200 Hz to 8.0 kHz / Resolution: 1 Hz
*RST setting 1000 Hz
Programming Example
OUTPUT 714;"SETUP:AAUDIO:FILTER :SFREQUENCY 1000" !This is a complex command that
SETup:AAUDio:FILTer:FREQuency
Function Sets/queries the center frequency for the 100 Hz bandpass filter applied to Analog Audio
measurements. Units (KHZ|HZ) are optional, if no units are specified then units default to Hz.
see "SETup:AAUDio" on page 380
Setting Range: 200 Hz to 8.0 kHz / Resolution: 1 Hz
Query Range: 200 Hz to 8.0 kHz / Resolution: 1 Hz
*RST setting 1 kHZ
Programming Example
OUTPUT 714;"SETUP:AAUDIO:FREQUENCY 217HZ" !Set aaudio bandpass filter to 217 hz.
382
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_setup_aaudio.fm
see"Analog Audio Measurement Description" on page 44
!Analog Audio measurements
!to +5 volts.
!sets the aaudio filter state
!to on and sets the bandpass
!filter frequency to 1 kHz.