Call Processing Subsystem Overlapped Commands - Agilent Technologies 8960 10 Series Reference Manual

Call Processing Subsystem Overlapped Commands

Table 1 of 2
Call Processing Command
CALL:ORIGinate
See "CALL:ORIGinate" on page
CALL:END
See "CALL:END" on page
CALL[:CELL[1]]:BCHannel[:ARFCn][:SELected]
See "CALL[:CELL]:BCHannel[:ARFCn][:SELected]" on
page 236.
CALL[:CELL[1]]:BCHannel[:ARFCn]:<broadcast band>
See "CALL:BCHannel" on page
267.
247.
236.
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\prog_synch_callproc.fm
Purpose Of Command Pending Operation Flag (POF) is
false when
Performs a base The call processing state
station call leaves the Idle state (when the
origination. operating mode is active cell),
or
The test set has noted this
parameter change (when the
operating mode is test mode).
Performs a base The call processing state
station call reaches the Idle state (when
termination. the operating mode is active
cell), or
The test set has noted this
parameter change (when the
operating mode is test mode).
Sets the BCH The downlink signal is
ARFCN for transmitting on the new
currently selected broadcast channel.
broadcast band.
Sets the BCH The test set has noted this
ARFCN for a parameter change.
broadcast band not
currently selected.
Call Processing Event Synchronization
33