Configuring the Broadcast Channel (BCH)
Configuring the Broadcast Channel (BCH)
The broadcast channel parameters are configured using the following call processing subsystem commands.
For complete command syntax, refer to
"CALL:BCHannel" on page 236
for GPIB commands.
BCH Parameters
• Cell Band
• Cell Power
• Cell Power State
• Broadcast Chan (ARFCN)
• Mobile Country Code (MCC)
• Mobile Network Code (MNC)
• Location Area Code (LAC)
• Network Color Code (NCC)
• Base Station Color Code (BCC)
• Paging IMSI
• Repeat Paging
• Paging Mode
• Paging Multiframes
• Get IMEI at Call Setup
• TX Level FACCH Signaling
• BA Table
• 3 Digit MNC for PCS
Examples:
Cell Band
OUTPUT 714;"CALL:BAND PGSM"
would set the cell to the PGSM band. See
"CALL[:CELL]:BAND" on page
234.
Cell Power
OUTPUT 714;"CALL:POW -85 DBM"
would set the cell's RF transmitter power to −85 dBm. See
"CALL[:CELL]:POWer[:SAMPlitude]" on page
273.
Cell Power State
OUTPUT 714;"CALL:POW:STAT ON"
would turn on the cell's RF transmitter on. See
"CALL[:CELL]:POWer:STATe" on page
274.
511
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\gen_bse_bch.fm