Agilent Technologies 8960 10 Series Reference Manual page 502

Frequency Banded Parameters
Cell Band Parameter
• When the operating mode is active cell and the call connected state is idle, changes to the cell band
parameter will be reflected in the traffic band and manual band parameters as well.
• When the operating mode is active cell and the call connected state is connected, changes to the cell band
parameter will disconnect any call in progress.
• When the operating mode is test mode and the test function is set to BCH, the cell band parameter should
be used. See "CALL:FUNCtion:DOWNlink" on page
• When the operating mode is test mode and the test function is set to CW, the cell band parameter should be
used.
Example 1.
OUTPUT 714;"CALL:CELL:BAND EGSM" !Sets the broadcast band and traffic band to EGSM.
Traffic Band Parameter
• When the operating mode is active cell and the call connected state is connected, changes to the traffic band
parameter cause an inter-band channel assignment. See
119.
• When the operating mode is active cell and the call connected state is connected, changes to the traffic band
parameter are not reflected in the cell band or the manual band parameters.
• When the operating mode is test mode and the test function is set to BCH + TCH, the traffic band
parameter should be used. See
Example 2.
OUTPUT 714;"CALL:TCHANNEL:BAND DCS" !Sets the traffic band to DCS.
Manual Band Parameter
• When the receiver control parameter is set to manual, changes to the manual band parameter are not
reflected in the traffic band or cell band parameters.
• Setting the manual band parameter changes the receiver control parameter to manual.
• When the receiver control parameter is set to manual, changes to the cell band parameter set the receiver
control parameter to auto; however, the manual band parameter changes to match the cell band setting.
Users will need to set receiver control back to manual.
Example 3.
OUTPUT 714;"RFANALYZER:MANUAL:BAND DCS" !Sets the manual band to DCS.
502
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\gen_band_params_test.fm
249.
"CALL:FUNCtion:DOWNlink" on page
"Programming a Dualband Handover" on page
249.