SETup:BERRor:MANual:DELay
Function
Sets/queries the number of frames the test set will use to correlate uplink information bits with
downlink information bits when loop delay control mode is manual (AUTO OFF). To set the delay
mode to manual, refer to
This value is displayed in the Speech Frames Delay field when Auto is not displayed. (If you want
to display this value and Auto is currently displayed, press the front-panel key labeled OFF).
Refer to
how it is used in this measurement.
Setting
Range: 1 to 15
Resolution : 1
Query
Range: 1 to 15
Resolution : 1
*RST Setting
5
Programming Example
OUTPUT 714;"SETUP:BERROR:MANUAL:DELAY 4" !Set delay of 4 speech frames.
SETup:BERRor:SLControl
Function
Selects/queries the Signalling loopback control state for an BER measurement.
When signalling loopback control is set to on, the test set will automatically send the loopback for
Type A (residual) or Type B (non-residual)
type selected, and then set loopback to off when the measurement is complete.
The loopback type is controlled manually from the Mobile Loopback F12 key, see
"CALL:TCHannel:LOOPback" on page 291
command.
Setting
Range: 1 | ON | 0 | OFF
Query
Range: 1 | 0
*RST
1 | ON
Programming Example
OUTPUT 714;"SETUP:BERROR:SLCONTROL ON" ! Test set will send
"SETup:BERRor:LDControl:AUTO" on page
"Bit Error Measurement Description" on page 48
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\hpib_setup_berror.fm
for a description of frame delay and
loopback to the MS, based on the measurement
for a program example and details about the
! loopback type automatically
SETup:BERRor
388.
389