Agilent Technologies 8960 10 Series Reference Manual page 608

Revision Information
• Enhanced status subsystem for multi-format capability
The status subsystem has been enhanced with radio system nodes where necessary for future multi-format
capability. This will cause some status subsystem commands to be in error condition, unless they are
replaced with the modified commands. The commands are:
— STATus:QUEStionable:ERRors is now STATus:QUEStionable:ERRors:GSM
— STATus:QUEStionable:CALL is now STATus:QUEStionable:CALL:GSM
— STATus:OPERation:CALL is now STATus:OPERation:CALL:GSM
— STATus:OPERation:NMRReady is now STATus:OPERation:NMRReady:GSM
• Instrument configuration information available remotely
Information on the instrument hardware can be obtained through a remote command over the GPIB, and
through a remote command via the LAN and a web browser. For further information on the commands refer
to "Hardware Configuration Report" on page
• Enhanced instrument information on the Configuration Screen
The Instrument Information display on the Configuration Screen, now includes Subnet Mask and Gateway
Default information in a new, improved information display.
• *IDN? returns "Agilent Technologies" in the manufacturer's field where previously it returned
"Hewlett-Packard".
• RF Generator frequency range is now matched to the RF Receiver frequency range
Previously the RF Generator had a low end limit of 45 MHz, while the RF Receiver has always had a low
end limit of 292.5 MHz. The RF Generator is now limited to 292.5 MHz to enhance testability and
supportability of the test set.
A.02 Release - July 1999
Call Processing
•
Paging Mode selectable between "Reorganisation" or "Normal"
Measurements
•
Automatic closed loop settings as part of Normal BER and Fast BER measurements
•
3 kHz speech selection for Downlink Speech Source
Other
•
LAN subnet mask and LAN Default Gateway settable
•
Status Subsystem for GPIB queries of instrument status
•
Display Brightness
•
Display Automatic Backlight Dimming
608
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\secure_features.fm
562.