Figure 1. Typical Flow of Tasks Performed by Control Program
Programming the Agilent Technologies 8960 Series 10 for GSM Mobile Testing in Active Cell Operating Mode
No
Step 7:
Yes
Perform
intra-cell handover.
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Reference_Manual\Chapters\prog_prog_guide_intro.fm
Start
Step 1:
Set test set's operating
mode to active cell.
Step 2:
Configure base station
emulator (BSE).
Step 3:
Configure measurement
execution parameters.
Step 4:
Establish active link
with mobile station.
Step 5:
Set mobile station
operating conditions.
Step 6a:
Start set of concurrent
measurements.
Step 6b:
Determine if a
measurement
is done.
All measurements done.
Assign
mobile station
to new TCH?
No
Step 8:
Disconnect mobile
station from BSE.
Stop
Step 6: Make
measurements.
Step 6c:
Yes
Obtain set of
measurement results.
Introduction
155