Example Of Using Ping For An Ip Vpn Device - Avaya 8800 Troubleshooting Manual

Software troubleshooting tool configuration using CLI
-q
-s
-t <value>
<count>
Use the information in the following table to help you use the mplsping ipv4 <prefix/
len> and mplsping rsvp <lsp-name> commands.
count <value>
ttl <value>
source <value>

Example of using ping for an IP VPN device

Ping the IP VPN device:
ping 100.100.1.1 vrf 100 source 200.100.1.1 count 10 datasize
1446 count 10
PING 100.100.1.1: 1438 data bytes
1446 bytes from 100.100.1.1: icmp_seq=0. time=1.605 ms
1446 bytes from 100.100.1.1: icmp_seq=1. time=1.568 ms
1446 bytes from 100.100.1.1: icmp_seq=2. time=1.584 ms
1446 bytes from 100.100.1.1: icmp_seq=3. time=1.586 ms
1446 bytes from 100.100.1.1: icmp_seq=4. time=1.579 ms
1446 bytes from 100.100.1.1: icmp_seq=5. time=1.589 ms
1446 bytes from 100.100.1.1: icmp_seq=6. time=1.577 ms
1446 bytes from 100.100.1.1: icmp_seq=7. time=1.588 ms
1446 bytes from 100.100.1.1: icmp_seq=8. time=1.590 ms
1446 bytes from 100.100.1.1: icmp_seq=9. time=1.535 ms
----100.100.1.1 PING Statistics----
188 Troubleshooting
Variable
Variable
Comments? infodev@avaya.com
Value
Specifies quiet output (same as nonverbose mode).
Specifies that the ping should be retransmitted at
continuous intervals.
Specifies the no-answer timeout from 1 to 120
seconds.
Specifies the number of times to ping the device from
1 to 9999. The default is 1.
Value
Specifies the number of times to ping the device from
1 to 1000. The default is 1.
Specifies the time-to-live of the MPLS ping packet
from 1 to 255.
Specifies the source IP address.
July 2013