Avaya 8800 Troubleshooting Manual page 63

Name
key exchange failed
no matching cipher
found: client aes256-
cbc,rijndael256-
cbc,rijndael-
cbc@lysator.liu.se,aes192
-cbc,rijndael192-
cbc,aes128-
cbc ,rijndael128-
cbc,3des-cbc,blowfish-
cbc server
HW INFO System activity
performed
HW ERROR FAD Mis-Align
detected, SWIP Reset
Status=8. Total=4
Troubleshooting
Description
SSH authentication failed.
No cipher found.
This is a generic message
indicating an activity has
been performed. In many
cases the message is
followed by the activity
performed, such as STP
change, routing change,
and user logon.
FAD Errors: The Fabric
Access Device (FAD) is a
module in the SSF that
participates in sending
packets to the Backplane.
This is ASIC on SSF that
controls access to I/O
modules or backplane. The
Switch Processor (SWIP) is
the processor that controls
the SSF and FADs. The
error message indicates
that the hardware or
software has determined
that there exists a data error
(Mis-Alignment) from I/O to
SSF. Each I/O module is
connected through a high-
speed back plane bus to a
Switch Fabric on the CPU
SF module. All ingress and
Remedial Action
After entering the above information,
the switch prompts you to confirm the
information. Enter y Is this
correct (y/n) ? y
Enter save to save this information
and enter boot to reset the switch: *
monitor/mfg-diag# save
monitor/mfg-diag# boot
Verify the SSH client settings and
ensure that they match the settings in
8800/8600.
The message is information only. No
action required
If you see this message frequently,
contact Avaya Technical Support.
*
July 2013 63