Determining the protocol configured on the added VLAN
The protocol configured on the added VLAN can be one of the following values:
• snoop
• snoop-spb
• routed-spb
• pim
Procedure steps
Determine the protocol that is configured on the VLAN added by using the following
command:
show ip igmp interface [vrf <value>] [vrfids <value>]
The protocol is shown under the Mode column of the command output.
Variable definitions
Use the information in the following table to use the show ip igmp interface
command..
vrf <value>
vrfids <value>
Job aid: show ip igmp interface command
The following table shows the field descriptions for this command.
Table 26: Job aid: show ip igmp interface command output
IF
Troubleshooting
Variable
Specifies the VRF instance by the VRF name. The
VRF name ranges from 0 to 64)
Specifies the VRF ID for which to display statistics
Field
Determining the protocol configured on the added VLAN
Value
Description
Indicates the interfaces where IGMP is configured
July 2013
405