Avaya 8800 Troubleshooting Manual page 228

Software troubleshooting tool configuration using ACLI
3. Disable the RSP ingress Packet Tracing by using the following command:
Variable definitions
The following table describes variables that you enter in the rsp-trace ingress-pkt-
trace or the config rsp-trace egress-pkt-trace command.
<slot/port>
enable
[<interval-value>]
228 Troubleshooting
Note:
Only the ports in lanes on which the trace is enabled are displayed
no rsp-trace ingress-pkt-trace <slot/port> enable
OR
Disable the RSP egress Packet Tracing by using the following command:
no rsp-trace egress-pkt-trace <slot/port> enable
Variable
Comments? infodev@avaya.com
Value
Specifies the port on which to enable Packet
Tracing.
Important:
Although you specify only one port, the
Packet Tracing is enabled on all ports in
that lane. The info command displays all
ports in that lane so that you do not enable
Packet Tracing on the same RSP through
a different port.
Enables the state of the ingress or egress
Packet Tracing. By default the trace is
enabled for 1 second. After 1 second, the
trace is disabled internally. An optional
parameter, interval, is provided to keep the
trace enabled for the desired number of
seconds.
Important:
RSP Packet Tracing displays only the last
1024 packets captured.
Indicates the time interval for which the
Packet Tracing is to remain enabled.
<interval-value>
1, 10, 30 60, 120, or 300 seconds. The
default value is 1 second.
specifies a value of
July 2013