Avaya 8800 Troubleshooting Manual page 432

Troubleshooting the Unified Access solution
3. Check the status of all the access tunnels (AT) and mobility tunnels (MT) associated
4. Check the statistics for all of the tunnels configured on this switch or for a specific
5. Check the configuration information for all of the VLAN maps on this switch or for a
6. Check the VLAN IDs or specific VLAN IDs reserved in L3 Roaming:
7. Check the VLAN servers that the WSP use in L3 Roaming:
8. Check the Mobility VLANs advertised by the Peer WSP:
9. Check the WSP's peer device information:
10. Check the WLAN VLAN FDB entries that the WSP has learned:
432 Troubleshooting
(ACLI) show wireless switch lb-controller [<A.B.C.D>]
with this switch or for a specific tunnel:
(CLI) show wireless-switch tunnel [<tunnelIntfId>]
(ACLI) show wireless switch tunnel [<tunnelIntfId>]
tunnel:
(CLI) show wireless-switch tunnel-statistics all
[<tunnelIdList>]
(ACLI) show wireless switch tunnel-statistics [<tunnelIdList>]
Note:
The IN KEEPALIVE and OUT KEEPALIVE statistics should always be the same.
If they vary by 5 or more, it indicates that there is a problem. The lower number
indicates if the problem is in Keep Alive Receive or Keep Alive Transmit. Note
also that these statistics are cleared if the tunnel goes down.
specific VLAN map:
(CLI) show wireless-switch vlan-map [<name:WORD/0–32>]
(ACLI) show wireless switch vlan-map [<name:WORD/0–32>]
(CLI) show wireless-switch vlan-reservation [<vidList>]
(ACLI) show wireless switch vlan-reservation [<vidList>]
(CLI) show wireless-switch vlan-servers
(ACLI) show wireless switch vlan-servers
(CLI) show wireless-switch peer-advertized-vlans by-vlan
(CLI) show wireless-switch peer-advertized-vlans by-advertizer
(ACLI) show wireless switch peer-advertized-vlans by-vlan
(ACLI) show wireless switch peer-advertized-vlans by-
advertizer
(CLI) show wireless-switch peer-devices [ap | switch]
(ACLI) show wireless switch peer-devices [ap | switch]
Comments? infodev@avaya.com
July 2013