Avaya 8800 Troubleshooting Manual page 109
Ethernet routing switch
Hide thumbs
Also See for 8800:
- Planning and engineering, network design (327 pages) ,
- Planning and engineering (306 pages) ,
- Configuration manual (226 pages)
Table of Contents
Advertisement
Name
ConfiguredServerPort
ConfiguredAltServerAddrType
ConfiguredAltServerAddr
SupportedApps
AgentAddressType
AgentAddress
AgentPort
RegisteredWithServer
RegisteredServerAddrType
RegisteredServerAddr
RegisteredServerPort
RegistrationTime
AgentToAgentPort
ConfiguredAgentToAgentPort
Troubleshooting
Configuring the SLA Monitor agent
Description
Restricts the agent to use of this registration
port only. The default is 0, which means the
agent disregards the source port information
in server traffic. The server must use the
same port.
Specifies the address type of the secondary
server: IPv4.
Configures a secondary server in the event
that the primary server is unreachable.
Shows the type of testing supported: Real
Time Protocol (RTP) and New Trace Route
(NTR).
Shows the agent address type.
Shows the configured agent IP address.
Shows the configured agent port.
Indicates if the agent has registered with a
server.
Shows the address type for the registered
server.
Shows the IP address for the registered
server.
Shows the port number for the registered
server.
Shows the amount of time, in seconds, since
the agent registered with the server.
Shows the port for agent-to-agent
communication.
Configures the port used for RTP and NTR
testing in agent-to-agent communication.
The default port is 50012. If you configure
this value to zero (0), the default port is
used.
July 2013
109
Advertisement
Table of Contents
Troubleshooting
