Avaya 8800 Troubleshooting Manual page 288

SNMP trap configuration using CLI
2. Ensure that the configuration is correct:
Variable definitions
Use the information in the following table to help you use the config snmp-v3 target-
param command.
create <Tparm Name> mp-
model <value> sec-level
<value> [sec-name <value>]
delete <Tparm Name>
info
mp-model <Tparm Name> new-
mpmodel <value>
sec-level <Tparm Name> new-
seclevel <value>
sec-name <Tparm Name> [new-
secname <value>]
Example of configuring additional target parameters
288 Troubleshooting
config snmp-v3 target-param create <Tparm Name> mp-model
<value> sec-level <value> [sec-name <value>]
config snmp-v3 target-param info
show snmp-v3 target-param
Variable
Specifies target table parameters.
Deletes the specified target parameter table.
Displays information for the target parameter table.
Specifies the new SNMP version. The valid options are
snmpv1, snmpv2c, and usm (SNMPv3).
Specifies a new security level. The valid options are
noAuthNoPriv, authNoPriv, and authPriv.
Specifies a new security name (readview or writeview),
which identifies the principal that generates SNMP
messages.
Comments? infodev@avaya.com
• <Tparm Name> is the name of the target parameter
with a string length of 1 to 32.
• mp-model <value> specifies the MP model. The valid
options are snmpv1, snmpv2c, and usm (SNMPv3).
• sec-level <value> specifies the security level as
noAuthNoPriv, authNoPriv, or authPriv.
• <sec-name> specifies the security name with a string
length of 1 to 32.
Value
July 2013