Configuring Snmp Interfaces - Avaya 8800 Troubleshooting Manual

Configuring SNMP interfaces

If the Avaya Ethernet Routing Switch 8800/8600 has multiple interfaces, configure the IP
interface from which the SNMP traps originate.
Prerequisites
• Access Global Configuration mode.
Procedure steps
1. Configure the destination and source IP addresses for SNMP traps:
2. If required, send the source address (sender IP) as the sender network in the
3. If required, force the SNMP and IP sender flag to be the same:
Variable definitions
Use the information in the following table to complete the snmp-server command.
agent-conformance
enable
authentication-trap
enable
force-iphdr-sender
enable
Troubleshooting
snmp-server sender-ip <A.B.C.D> <A.B.C.D>
notification message:
snmp-server force-trap-sender enable
snmp-server force-iphdr-sender enable
Variable Value
Enables the agent conformance mode. Conforms to
MIB standards when disabled. If you activate this
option, feature configuration is stricter and error
handling less informative. Activating this option is not
a recommended or normally supported mode of
operation.
Activates the generation of authentication traps.
Enables the automatic configuration of the SNMP and
IP sender to the same value. The default is false.
Configuring SNMP interfaces
July 2013 317