Configuring System Message Control - Avaya 8800 Troubleshooting Manual
Ethernet routing switch
Hide thumbs
Also See for 8800:
- Planning and engineering, network design (327 pages) ,
- Planning and engineering (306 pages) ,
- Configuration manual (226 pages)
Table of Contents
Advertisement
Variable
<true|false>
Configuring system message control
Configure system message control to suppress duplicate error messages on the console, and
to determine the action to take if they occur.
Procedure steps
1. Configure system message control action by using the following command:
2. Configure the maximum number of messages by using the following command:
3. Configure the interval by using the following command:
4. Enable message control:
Variable definitions
Use the information in the following table to complete the config sys set msg-
control command.
action <suppress-msg|
send-trap|both>
control-interval
<minutes>
Troubleshooting
Begin or stop the logging of system messages on the PCMCIA
(or external flash) card. If true is specified, the following
message appears:
false is specified, the following message appears:
to PCMCIA STOPPED
config sys set msg-control action <suppress-msg|send-trap|
both>
config sys set msg-control max-msg-num <number>
config sys set msg-control control-interval <minutes>
config sys set msg-control enable
Variable
Value
Logging to PCMCIA STARTED
.
Value
Configures the message control action. The default
value is supress-msg.
Configures the message control interval in minutes.
The valid options are 1 to 30. The default value is
5.
Configuring system message control
. If
Logging
July 2013
305
Advertisement
Table of Contents
Troubleshooting
