Showing the SPBM multicast database
You can determine the database used by the SPBM multicast module by using the following
procedure:
Procedure steps
Show the SPBM multicast database by using the following command:
show isis spbm ip-multicast-route [all | detail | group
{A.B.C.D}| vlan <0–4094> | vrf WORD<0–64> | vsn-isid <1–
16777215>]
Job aid: show isis spbm ip-multicast-route command
The following table describes fields for this command.
Table 37: show isis spbm ip-multicast-route command
VRF Source
Group
VSN-ISID
Data ISID
BVLAN
Source-BEB
Defining the IS-IS trace flag for IP multicast
To define the IS-IS trace flag for IP multicast, use the following procedure:
Troubleshooting
Field
Specifies the IP address of the Global Routing Table
Specifies the IP multicast group for which this entry
specifies a next hop on an outgoing interface
Specifies the VSN I-SID
Specifies the VRF ID for the multicast route
Specifies the backbone VLAN
Specifies the source backbone edge bridge
Showing the SPBM multicast database
Description
July 2013
423