Avaya 8800 Troubleshooting Manual page 102

Software troubleshooting tool configuration using Enterprise Device Manager
DataSize
TimeOut
ProbesPerHop
Port
MaxTtl
DSField
SourceAddressType
SourceAddress
IfIndex
MiscOptions
MaxFailures
DontFragment
InitialTtl
Frequency
StorageType
102 Troubleshooting
Variable
host is not on a directly-attached network, an error is
returned. This option can be used to perform the
traceroute operation to a local host through an interface
that has no route defined.
Specifies the size of the data portion of a Trace Route
request in octets. The default is 0.
Specifies the timeout value, in seconds, for a Trace
Route request. The default is 3.
Specifies the number of times to reissue a Trace Route
request with the same time-to-live (TTL) value. The
default is 3.
Specifies the UDP port to which to send the traceroute
request to. Specify a port that is not in use at the
destination (target) host. The default is the IANA
assigned port 33434.
Specifies the maximum time-to-live from 1 to 255. The
default is 30.
Specifies the value to store in the Differentiated Services
(DS) field in the IP packet used to encapsulate the Trace
Route probe.
Specifies the type of the source address to use at a
remote host.
Uses the specified IP address (which must be given as
an IP number, not a hostname) as the source address in
outgoing probe packets.
Directs the traceroute probes to be transmitted over the
specified interface
Enables an application to specify implementation-
dependent options.
Indicates the maximum number of consecutive timeouts
allowed before terminating a remote Trace Route
request. The default is 5.
Enables setting of the do not fragment flag (DF) in the IP
header for a probe.
Specifies the initial TTL value to use. The default is 1.
Specifies the number of seconds to wait before repeating
a trace route test as defined by the value of the various
objects in the corresponding row. The default is 0.
Specifies the storage type for this row.
Comments? infodev@avaya.com
Value
July 2013