SNMP trap configuration using CLI
Enabling SNMP trap logging
Use SNMP trap logging to send a copy of all traps to the PCMCIA card (or external flash on
the 8895 SF/CPU).
Prerequisites
• Install a PCMCIA or external flash card.
Procedure steps
1. To enable SNMP trap logging, use the following command:
2. To set the maximum file size:
3. Ensure that the configuration is correct:
4. To view the contents of the SNMP log, use the following command:
Variable definitions
Use the information in the following table to help you use the config snmp snmplog
command.
<enable|disable>
info
maxfilesize <64-256000>
292
Troubleshooting
config snmp snmplog enable true
config snmp snmplog maxfilesize <64-256000>
show snmp snmplog info
show snmplog file [tail] [grep <value>]
Variable
Comments? infodev@avaya.com
Enables or disables the logging of traps.
Displays information about SNMP logging.
Specifies the maximum file size for the trap log.
Value
July 2013