Configuring Remote Mirroring; Prerequisites; Procedure Steps - Avaya 8800 Troubleshooting Manual

Software troubleshooting tool configuration using ACLI
count enable
mirror enable
monitor-dst-ports
<portList>
monitor-dst-mlt
<1-256>
monitor-dst-vlan
<0-4094>

Configuring remote mirroring

Use remote mirroring to monitor many ports from different switches using one network probe
device.

Prerequisites

• Access Interface Configuration mode.

Procedure steps

1. Configure remote mirroring using the following command:
2. Ensure that the remote mirroring configuration is correct:
242 Troubleshooting
Variable
Enables the ability to count matching packets.
Enables mirroring.
If you enable mirroring, ensure that you configure the
appropriate parameters:
• For R and RS/8800 modules in Rx mode:
• For R modules in Tx mode: use the
Configures mirroring to a destination port or ports.
Configures mirroring to a destination MLT group.
Configures mirroring to a destination VLAN.
remote-mirroring [enable] [mode <source|termination>]
[srcMac <0x00:0x00:0x00:0x00:0x00:0x00>] [dstMac
<0x00:0x00:0x00:0x00:0x00:0x00>] [ether-type <0x00-0xffff>]
[vlan-id <1-4094>]
show remote-mirroring interfaces <fastEthernet|
gigabitEthernet> [enable] [mode <source|termination>]
Comments? infodev@avaya.com
dst-ports , monitor-dst-vlan
dst-mlt
.
port commands to specify the mirroring source/
destination.
Value
monitor-
, or monitor-
mirror-by-
July 2013