Viewing The Trap Sender Table; Configuring An Snmp Notify Table - Avaya 8800 Troubleshooting Manual

SNMP trap configuration using Enterprise Device Manager
SecurityModel
SecurityName
SecurityLevel

Viewing the trap sender table

Use the Trap Sender Table tab to view source and receiving addresses.
Procedure steps
1. In the navigation tree, open the following folders: Configuration > Edit.
2. Click Chassis.
3. Click the Trap Sender Table tab.
Variable definitions
Use the information in the following table to use the Trap Sender Table tab.
Variable
RecvAddress
SrcAddress

Configuring an SNMP notify table

Configure the notify table to select management targets to receive notifications, as well as the
type of notification to send to each management target.
272 Troubleshooting
Variable
Specifies the security model to use to generate
messages: SNMPv1, SNMPv2c, or USM. You can
receive an inconsistentValue error if you try to configure
this variable to a value for a security model that the
implementation does not support.
Identifies the principal on whose behalf SNMP messages
are generated.
Specifies the security level used to generate SNMP
messages: noAuthNoPriv, authNoPriv, or authPriv.
Specifies the IP address for the trap receiver. This field is a read-only
parameter that contains the IP address configured in the TAddress field
in the TargetTable.
Identifies the IP address for the trap sender.
Comments? infodev@avaya.com
Value
Value
July 2013