Avaya 8800 Troubleshooting Manual page 84

Software troubleshooting tool configuration using Enterprise Device Manager
3. Click the ACL tab.
4. Select the ACL for which to modify an ACE.
5. Click ACE.
6. Select an ACE and click Action/Debug.
7. In Flags, select mirror.
8. For R and RS/8800 modules in Rx mode : configure one of: DstPortList,
Variable definitions
Use the information in the following table to help you configure ACEs.
AceId
AclId
Name
AdminState
OperState
Mode
MltIndex
84 Troubleshooting
Caution:
Risk of packet loss
If not absolutely necessary, Avaya recommends that you do not select
copyToPrimaryCp or copyToSecondaryCp. Selecting the copyToPrimaryCp
parameter causes packets to be sent to the CP, which can overwhelm it. You can
use PCAP, the Packet Capture Tool, rather than selecting the parameter
copyToPrimaryCp.
DstVlanId, or DstMltId.
OR
For R modules in Tx mode: configure the Edit, Diagnostics, Port Mirrors tab.
Variable
Specifies a unique identifier and priority for the ACE.
Specifies the ACL ID.
Specifies a descriptive, user-defined name for the ACE. The
system automatically assigns a name if one is not chosen.
Indicates whether the ACE is enabled. An ACE can only be
modified if it is disabled.
The current operational state of the ACE.
Indicates the operating mode associated with this ACE.
Valid options are deny and permit, with deny as the
default.
Specifies whether to override the MLT-index picked by the
MLT algorithm when a packet is sent out on MLT ports. Valid
values range from 0 to 8, with 0 as the default. MLT index
is not supported for multicast traffic, but for unicast traffic
only.
Comments? infodev@avaya.com
Value
July 2013