Software troubleshooting tool configuration using CLI
destination <ipaddr>
[next-hop-mac <mac>]
[port <port>] [vlan <vlan
Id>]
enable
disable
info
Using the shell debug wrapper commands
The shell debug wrapper commands group multiple shell commands under one command.
With this feature, you can enter one command to display the output of all the related shell
commands in that group. This eliminates the need for you to remember the names of all the
individual commands and makes it easier to enter just one command, which should facilitate
debugging.
The shell debug wrapper commands are separated into the following groups:
• generic (general shell and CPP commands)
• platform
• bridging
• routing
• multicast
• spbm (Shortest Path Bridging commands)
124
Troubleshooting
Variable
Comments? infodev@avaya.com
Value
Configures the destination IP address of the syslog
packets, which is the IP address of the syslog server
or relay).
<ipaddr>
•
specifies the IP address in the format
xx.xx.xx.xx.xx.xx
•
<mac>
specifies the MAC address of the next hop
towards the destination.
•
<port>
specifies the port number in slot/port
format.
•
<vlan Id>
identifies the VLAN that the port
belongs to. The range is 1..4094.
Enables trace syslog.
Note:
Before enabling Syslog tracing, you must
configure a destination IP address.
Syslog tracing is disabled by default.
Disables trace syslog.
Syslog tracing is disabled by default.
Shows the configured values for Syslog tracing.
.
July 2013