Administrator Unable To Receive Trap Packets From The Avaya Ethernet Routing Switch 8800/8600; User Unable To Login - Avaya 8800 Troubleshooting Manual
Ethernet routing switch
Hide thumbs
Also See for 8800:
- Planning and engineering, network design (327 pages) ,
- Planning and engineering (306 pages) ,
- Configuration manual (226 pages)
Table of Contents
Advertisement
2. Check whether accounting is enabled on TACACS+ server.
Administrator unable to receive trap packets from the Avaya
Ethernet Routing Switch 8800/8600
If the administrator is unable to receive trap packets from the Avaya Ethernet Routing Switch
8800/8600, perform the following steps.
Procedure steps
1. To check whether the trap server is configured correctly on the Avaya Ethernet
2. Check whether there is a firewall between the Avaya Ethernet Routing Switch
User unable to login
1. Check the configurations on the switch, especially the server IP address and key,
2. If the server is directly connected, then check if the administrative and operation
Troubleshooting
show tacacs server config
OR
enter the following ACLI command:
show tacacs
Routing Switch 8800/8600, enter the following CLI command.
show snmp-v3 target-addr
OR
enter the following ACLI command
show snmp-server host
8800/8600 and the trap server.
using the following CLI command:
show tacacs server config
OR
using the following ACLI command
show tacacs
status of the port is up using the following CLI command:
Troubleshooting TACACS+
July 2013
461
Advertisement
Table of Contents
Troubleshooting
