Configuring The Sla Monitor Agent - Avaya 8800 Troubleshooting Manual

14. To configure the source IP address, in the Source Address tab, click Insert.
15. To configure the destination IP address, in the Destination Address tab, click
16. In the ACE Common tab, configure the AdminState of the Ping Snoop ACE to

Configuring the SLA Monitor agent

Configure the SLA Monitor agent to communicate with an SLA Monitor server to perform
Quality of Service (QoS) tests of the network.
Before you begin
• To use the SLA Monitor agent, you must have an SLA Monitor server in your network.
About this task
To configure the agent, you must enable it and assign an IP address. Remaining agent
parameters are optional and you can operate the agent using the default values.
In HA mode, the agent startup and initialization occurs only on the master CP module.
Procedure
1. In the navigation tree, expand the following folders: Configuration >
2. Click SLA Monitor.
3. Click the SLA Monitor tab.
4. Select enabled.
5. Type the agent IP address in the ConfiguredAgentAddr field.
6. Configure optional parameters as required.
7. Click Apply.
Troubleshooting
Configure Oper to eq and type the IP address in the List box, and then click
Insert.
Insert. Configure Oper to eq and type the IP address in the List box, and then click
Insert.
enable and click Apply.
Serviceability.
Configuring the SLA Monitor agent
July 2013 107