shell debug wrapper commands
The shell debug wrapper commands group multiple shell commands under one command.
With this feature, you can enter one command to display the output of all the related shell
commands in that group. This eliminates the need for you to remember the names of all the
individual commands and makes it easier to enter just one command, which should facilitate
debugging.
The shell debug wrapper commands are separated into the following groups:
• generic (general shell and CPP commands)
• platform
• bridging
• routing
• multicast
• spbm (Shortest Path Bridging commands)
Important:
In some cases, these debug commands can take a long time to display the information on the
screen. To avoid displaying messages on the console screen, enter config log screen
off.
Enter these commands in Privileged Exec Mode. You can only enter one command for any
group at a given point of time.
Using the show debug generic command
Use the show debug generic [verbose] command for debugging purposes only.
The following table describes the commands displayed by the show debug generic
command. The table also lists the recommended number of times to execute the command
(once or twice) in order to obtain best results for meaningful analysis of the specified data.
Executing the command twice allows for an analysis of data at two different time periods.
Table 15: show debug generic commands
Command
readrtc
Troubleshooting
Definition
Displays the local and hardware time.
shell debug wrapper commands
For best
results
execute twice
July 2013
211