Dumping Rsp Packet Tracing - Avaya 8800 Troubleshooting Manual

Software troubleshooting tool configuration using CLI
Job aid
The following table describes the fields for the config rsp-trace info command.
ingress-pkt-trace:/egress-pkt-trace:
port
state
interval

Dumping RSP packet tracing

Dump the RSP packet tracing to display the ingress and egress RSP tracing information that
is collected by enabling the tracing.
Procedure steps
Important:
The CLI command accepts only a single port.
Important:
RSP packet tracing displays only the last 1024 packets captured.
1. Display the specific egress RSP packet by using the following command:
140 Troubleshooting
Field
dump rsp-trace egress-display-pkt port <value> pkt-id <value>
OR
Comments? infodev@avaya.com
Description
Specifies the packet tracing as ingress or
egress.
Specifies all the ports in the lane on which
the trace is enabled.
Important:
After the trace is disabled internally (when
the interval timer expires), the ports are
not displayed in the output of the
rsp-trace info
Specifies whether packet tracing is
enabled.
Specifies the interval in seconds for which
the packet tracing is enabled.
config
command.
July 2013