Avaya 8800 Troubleshooting Manual page 420

Multicast troubleshooting using the ACLI
Procedure steps
Determine the protocol that is configured on the VLAN added by using the following
command:
show ip igmp interface [vrf <value>] [vrfids <value>]
The protocol is shown under the Mode column of the command output.
Variable definitions
Use the information in the following table to use the show ip igmp interface
command..
vrf <value>
vrfids <value>
Job aid: show ip igmp interface command
The following table shows the field descriptions for this command.
Table 35: Job aid: show ip igmp interface command output
IF
QUERY INTVL
MODE
STATUS
VERS
OPER VERS
420 Troubleshooting
Variable
Specifies the VRF instance by the VRF name
Specifies the VRF ID for which to display statistics
Field
Comments? infodev@avaya.com
Value
Description
Indicates the interfaces where IGMP is configured
Indicates the frequency at which the interface
transmits IGMP host query packets
Specifies the protocol used on the added VLAN. The
value is snoop, snoop-spb, routed-spb or pim.
Indicates the activation of a row that enables IGMP on
the interface. The destruction of a row disables IGMP
on the interface.
Indicates the version of IGMP that is running on this
interface. This object configures a router capable of
running either version. For IGMP to function correctly,
you must configure all routers on a LAN to run the
same version of IGMP.
Indicates the operational version of IGMP.
July 2013