Job aid
Use the information in the following table to understand the test parameters.
IfIndex
Result
PassCount
FailCount
Testing the ARP address table
You can test the Address Resolution Protocol address table for consistency.
Prerequisites
• Access Privileged EXEC mode.
Procedure steps
1. Test the address table by entering the following command.
2. Stop the test after a few seconds:
3. View the results of the test:
Troubleshooting
PassCount: 62115
FailCount: 0
Field
test artable
test stop artable
show test artable
Description
Specifies the interface index, if applicable.
Shows the result of the most recently run (or current)
test: none, success, inProgress, notSupported,
unAbleToRun, aborted, failed.
Specifies the number of iterations of the test case that
completed successfully.
Specifies the number of iterations of the test case that
failed.
Testing the ARP address table
July 2013
257