SNMP trap configuration using the ACLI
Variable definitions
Use the information in the following table to use the snmp-server host <WORD 1-256>
port <1-65535> command.
v1 <WORD 1-32> [filter
<WORD 1-32>] [target-
name <WORD 1-32>]
v2c <WORD 1-32> [inform
[mms <0-2147483647>]
[retries <0-255>]
[timeout
<0-2147483647>]]
[filter <WORD 1-32>]
[target-name <WORD
1-32>]
v3 {noAuthnoPriv|
authNoPriv|AuthPriv}
<WORD 1-32> [inform
[retries <0-255>]
[timeout
<0-2147483647>]]
314
Troubleshooting
Variable
Creates a new SNMPv1 entry for the target address
table.
Creates a new SNMPv2c entry for the target address
table.
Creates a new SNMPv3 entry for the target address
table.
Comments? infodev@avaya.com
Value
•
<WORD 1-32>
specifies the security name, which
identifies the principal that generates SNMP
messages.
•
filter <WORD 1-32>
to use.
• target-name <WORD 1-32> is the target name with
a string length of 1 to 32.
•
<WORD 1-32>
specifies the security name, which
identifies the principal that generates SNMP
messages.
•
inform
indicates that SNMP notifications should be
sent as inform (rather than trap).
mms <0-2147483647>
•
message size as an integer with a range of 1 to
2147483647. The default value is 484.
•
retries <0-255>
with a range of 0 to 255. The default values is 3.
•
timeout <0-2147483647>
timeout value in seconds with a range of 0 to
214748364. The default value is 1500.
filter <WORD 1-32>
•
to use.
• target-name <WORD 1-32> is the target name with
a string length of 1 to 32.
specifies the filter profile
specifies the maximum
specifies the retry count value
specifies the
specifies the filter profile
July 2013