Defining The Is-Is Trace Flag For Ip Multicast - Avaya 8800 Troubleshooting Manual
Ethernet routing switch
Hide thumbs
Also See for 8800:
- Planning and engineering, network design (327 pages) ,
- Planning and engineering (306 pages) ,
- Configuration manual (226 pages)
Table of Contents
Advertisement
Source-BEB
Defining the IS-IS trace flag for IP multicast
To define the IS-IS trace flag for IP multicast, use the following procedure:
Procedure steps
Define the IS-IS trace flag by using the following command:
trace flags isis [set ip-multicast] [remove ip-multicast]
Troubleshooting
Field
Specifies the source backbone edge bridge
Defining the IS-IS trace flag for IP multicast
Description
July 2013
409
Advertisement
Table of Contents
Troubleshooting
