Using The Show Debug Platform Command; Using The Show Debug Bridging Command - Avaya 8800 Troubleshooting Manual

Table 16: show debug generic verbose commands
Command
sysCliShowPerf ;
netStackSysPool
Show
fbufDump
cppQShow
hwDumpAll

Using the show debug platform command

Use the show debug platform [verbose] command for debugging purposes only. Enter
this one command to show the output of the following commands:
framework_dump
fm_mem_show
dumpPcapFrame
portRemoteMirrorTblDump

Using the show debug bridging command

Use the show debug bridging <value> command for debugging bridging problems only.
To use this command, you must enter one of the following subgroup parameters:
eap high-port <value> [low-port <value>]
mlt vlan <value>[low-mlt <value>] [high-mlt <value>] [low-port
<value>] [high-port <value>]
• low-mlt <value> = mlt id {1..128}
• high-mlt <value> = mlt id {1..128}
• low-port <value> = portnumber {slot/port[-slot/port][,...]}
• high-port <value> = portnumber {slot/port[-slot/port][,...]}
Troubleshooting
Displays system performance parameters like CPU/SF/
Buffer utilizations and DRAM info; displays memory
buffer information.
Displays statistics about all queues.
Displays CPP queue statistics.
Dumps most of the hardware records.
Command
Definition
Definition
Displays information about the registered
entities.
Displays information about the framework
memory manager block array.
Displays PCAP output but only on the slave
shell, not on the master.
Displays information about the remote
mirroring port table
shell debug wrapper commands
For best
results
execute twice
execute once
execute once
execute once
July 2013 213