Avaya 8800 Troubleshooting Manual page 65

Name
8600 4.1.4 COP SW
ercdProcIpRecMsg: Failed
to Delete IP Record
rcdIndexReadEntry: The
RSP 0 is not up
ercdGetLaneEqStats:
Failed to read EQ stats
for lane 0
rcdWriteRsp: The RSP 0
is not up
ercdWriteEgressMgidTable:
rcdWriteRsp of MGID
record failed
rcdWriteRsp: The RSP 0
is not up
ercdEgressPortRecUpdate:
rcdIndexWriteEntry()
Failed to Update Port
record
rcdWriteRsp: The RSP 0
is not up
msgControl: messages
Troubleshooting
Description
the processor that controls
the SSF and FADs. The
error message indicates
that the hardware/software
has found a data error (Mis-
Alignment) from I/O to SSF.
If this occurs frequently,
SWIP is reset to try to
resolve the issue. It is OK to
see a few of these
messages, however, if you
see a lot, the probable
cause is SSF. Each I/O
module is connected via a
high-speed back plane bus
to a Switch Fabric on the
CPU SF module. All ingress
and egress traffic, even if it's
contained on the same I/O
module port, passes across
the high-speed back plane
bus through the Switch
Fabric. To guard against
data bit errors, the CPU
software continuously
monitors the data integrity
between I/O modules and
CPU Switch Fab.
R module coprocessor
failed to delete IP record.
The RSP (Route Switch
Processor) is not up. For
Lane 0, the Co=Processor
failed to read the Egress
Queue stats. Writing the
record to the RSP memory
failed.
Remedial Action
Fix for COP SW "failed to delete ip
record" now fixed in Release
4.1.6.2..Please update to Release
4.1.6.2 or later.
Contact Avaya Technical Support.
July 2013 65