Configuring The Remote Host Address For Log Transfer - Avaya 8800 Troubleshooting Manual

Configuring the remote host address for log transfer

Configure the remote host address for log transfer. The system transfers the current log file to
a remote host when the log file size reaches the configured maximum size.
Prerequisites
• The IP address you configure for the remote host must be reachable at the time of
configuration.
Procedure steps
1. Configure the remote host address for log transfer by using the following command:
2. You can specify the file name:
3. To show the configured IP address and the file name for the remote host, use the
Variable definitions
Use the information in the following table to help you use the config log transferFile
<id> command.
add-IP <ipaddr>
Troubleshooting
config log transferFile <id> add_IP <ipaddr>
<id> specifies the ID for the remote host. The range is 1 to 10.
config log transferFile <id> filename <str>
This command sets the IP address for the remote host to the default (0.0.0.0).
following command:
config log transferFile <id> info
Variable
Specifies the IP address of the host to where the log file
needs to be transferred. Specify the IP address in the
format a.b.c.d. The remote host must be reachable or the
configuration fails.
Configuring the remote host address for log transfer
Value
July 2013 301